EC2304 MICROPROCESSOR AND MICRO CONTROLLERS NOV/DEC 2010 ANNA UNIVERSITY QUESTION PAPER ...


EC2304 MICROPROCESSOR AND MICRO CONTROLLERS NOV/DEC 2010 ANNA UNIVERSITY QUESTION PAPER ...


Posted by R.Anirudhan


B.E/B.Tech. DEGREE EXAMINATION, Nov/Dec 2010

FIFTH SEMESTER
ELECTRONICS AND COMMUNICATION ENGINEERING
EC2304- MICROPROCESSOR AND MICRO CONTROLLERS
(Regulation 2008)



PART-A(10*2=20marks)
1.What are tri-state devices?
2.Mention the advantages of using the Direct Memory Access.
3.What is the purpose of the following commands in 8086?(a)AAD,(b)RCL
4.Write an 8086 assembly language program to multiply two 16 bit unsigned numbers to provide a 32 bit result.Assume that the two numbers are stored in CX and DX.
5.Give the salient features of the 8254 Programmable interval timer.
6.What is a Sample and Hold circuit?
7.What are the advantages of the register indirect addressing mode in 8051 microcontroller?
8.Write an 8051 program to monitor PI continuously for the value 63H.It should get out of the monitoring only if P1=63H.
9.How is the microcontroller used for the traffic light control application?
10.Differentiate microprocessor from microcontroller in system design.

PART B (5 16 = 80 Marks)

11(a)(i)Explain the 8085 bus structure with a neat sketch.
(ii)What are the peripheral I/O instructions?Write its syntax and explain the same with the timing diagram.

or
(b)Explain the 8086 interrupts types in detail.

12(a)Explain the 8086 bit manipulation instructions with an example for each.

or
(b)Write an 8086 program to convert BCD data to binary data.

13(a)Explain the 8279 keyboard and sisplay controller with a neat sketch.

or
(b)Describe the architecture and working of 8253 timer.

14(a)Assume that 5 BCD data items are stored in RAM locations starting at 40H as shown below.Write an 8051 program to find the sum of all the numbers.The result must be in BCD.
40=(71),41=(11),42=(65),43=(59),44(37)

or
(b)Explain the working of the 8051 microcontroller.Give a neat sketch.

15(a)Explain how microcontrollers and microprocessors can be used for the washing machine control application.Use sketches.

or
(b)Explain with a neat sketch how microcontrollers and microprocessors can be used for the stepper motor control application.




All Rights Reserved Anna University Important Questions 2014 Nov/Dec 2014 - iAnnauniversity |
| My Google+ Profile | Find us on Google+